IMPORTANT SAFETY INSTRUCTIONS Carefully read the following Important information redarding installation safety and maintenance. Keep these instruction
9 2. Locate the electrical outlet 12″ below the countertop. Install a manual shut-off valve in the gas line in an easily accessible location outside
10 Installation Instructions 1. INSTALLING THE COOKTOP A. Remove the screws on the sides of the cooktop burner box. Use those screws to attach the si
11 OPTION: You can install a 90º elbow (not supplied) onto the gas inlet and route the gas connections to avoid interference when installed over an
12 c) Place the burner caps on the burner heads. Make sure that the burner caps are properly seated on the burner heads. Burner cap properly seat
13 ·Test each valve separately until all burners have been checked. IMPORTANT: If the igniter electrodes continue to spark after all of the burners a
14 OPERATION CHECKLIST 1. Make sure all controls are left in the OFF position. 2. The serial plate for your cooktop is located on the bottom of the b
15 12"min,cutout to wall,both sides. 2-1/2"min,clearance to cutout 22.83“cooktop and vent area cutout 19.3"cutout depth 22.8″X 19.3&qu
16 jurisdiction. Failure to follow instructions could result in serious injury or property damage. The qualified agency performing this work assumes
17 NG position. Take out the retainer. LP position 2 CHANGE BURNER ORIFICES INSTALLATION TIP: First remove all orifices and then start replaci
18 A.Remove the burner grates, burner caps and burner heads. B.Using a 7mm nut driver, remove the top burner orifices. There are two orifices per bur
1 Safety Information & Installation Instruction BEFORE YOU BEGIN Read these instructions completely and carefully. ·IMPORTANT — Save these instr
19 ·If the flames were too small or fluttered, open the valve more than the original setting. ·If the flames blew away from the burner, close the va
20 CAUTION — The cooktop, as shipped from the factory, is set for use with its intended gas. If you wish to use your cooktop with the alternate gas,
21 NG position Take out the retainer. LP position 2) CHANGE BURNER ORIFICES INSTALLATION TIP: First remove all orifices and then start replaci
22 A.Remove the burner grates, burner caps and burner heads. B.Using a 7mm nut driver, remove the top burner orifices. There are two orifices per bur
23 ·If the flames were too small or fluttered, open the valve more than the original setting. ·If the flames blew away from the burner, close the va
24 Solutions to common problems Before calling for service, review this list. It may save you time and expenses. This list includes Common experience
2 3. If an external electrical source is utilized, a statement that the appliance, when installed, must be electrically grounded in accordance with l
TABLE OF CONTENTS SAFETY INFORMATION ... 1 FOR YOUR SAFETY …………………..
4 INSTALLATION PREPARATION PRE-INSTALLATION CHECKLIST 1. When preparing cooktop opening, make sure the inside of the cabinet and the cooktop do not i
5 TOOLS YOU WILL NEED FOR INSTALLATION Pencil Phillips-Head Screwdriver Ruler or Straightedge Safety Glasses Saber Saw Pipe Wrench 1/8″ Drill Bit
INSTALLATION OPTIONS Cooktop and Downdraft Vent Combination Installation These cooktops may be installed with a 36” Downdraft Vent. See page 12 for cu
7 3. Make sure the wall coverings, countertop and cabinets around the cooktop can withstand heat (up to 200°F) generated by the cooktop.
8 POWER SUPPLY LOCATIONS Gas supply: These cooktops are shipped from the factory set for either natural gas or LP gas. Check to be sure you have the
Kommentare zu diesen Handbüchern